Showing posts with label water conservation. Show all posts
Showing posts with label water conservation. Show all posts

Monday, August 31, 2009

The 15-minute grey-water barrel updated

At the beginning of summer, I converted an old trash can into a grey-water barrel in just 15 minutes. It was a project intended to conserve water by re-using bathwater on the garden. The initial project was only a partial success, thanks to a design flaw. But it didn't take much to fix the barrel. Here's what I did.

  1. Removed the silicone sealant that had failed.
  2. Bought two nuts for 1/2-inch threaded pipe, as well as common garden O-rings and hose washers.
  3. Put a nut on the faucet so that I could sandwich the barrel and washer snugly.
  4. Put faucet in hole, then on inside of barrel put on the washer (a tight fit, but better seal than the O-ring, which resulted in leaks).
  5. Tightened the nut.

The first thing I realized is that you'd need to be well over six feet tall or have really long wrench handles to do this by yourself. I recruited some help to hold the outside nut steady while I tightened the inside one.

The result had a very tiny, slow leak when I first filled the barrel. The volume wasn't something I was worried about, as it would take weeks, maybe months to lose a couple litres of water with the drip. All the same, I decided to put the barrel on a stack of old patio stones beside my deck, instead of on the wooden deck.

I found that once the barrel was filled, the leak stopped. Perhaps the moisture expanded the washer? At any rate, the stones under it have been dry ever since.

Simple to build, but how well does it work?
Filling it is a matter of carrying buckets of water from the bath. A quick shower can easily fill a 5-gallon bucket, and my son's baths yield 4-5 of them. It's actually kind of fun pouring the water off the side of the deck into the barrel below.

Watering from the barrel is less fun. The water isn't pressurized, so don't try to hook up a sprinkler. Unless you have a serious slope, it takes a long time to water by hose. I mainly used the grey water on my potted plants and some of the mid-season new seedlings. It takes some time to fill a bucket (a larger-diameter faucet would help), so I typically do some weeding while it fills.

Did the grey-water barrel save water?
A bit. This has been an unusually cool, wet summer. As a result, I haven't had to water the garden much. I've used no tap water at all on the potted plants, and have watered a couple beds using the barrel attached to a hose. I've probably filled and drained the barrel three or four times in total.

Were it a typically hot, sticky summer, it would have been much more useful. My son keeps asking me "Are we going to put my bath water in the barrel?" and is inevitably disappointed because the darned thing is still full, after weeks of rain. So a real test will have to wait until next summer, as will hooking up the rain barrel.

Tuesday, April 21, 2009

A grey-water barrel in 15 minutes!


Last year, the City of Toronto sent every residential building a new garbage bin as part of a program to limit the amount of trash going to landfill. A side-effect of this program is that there are now thousands of obsolete garbage bins that we can't use. Well, we can't use them as garbage bins.

I spent 15 minutes and turned mine into a grey-water barrel. I'll show you how to do it. (Please also see the update I posted here.)

There are, essentially, three categories of water: clean, grey and black. Clean is what you drink. Black is what flushes down your toilet. Grey is the stuff that's somewhere in between: it's your washing-up water and bath water. My barrel will be getting water from the bath. That water is fairly clean. It contains some dead skin cells and some soap, but nothing toxic or particularly nasty. Good stuff to use on the garden.

I started this project with a fairly standard plastic garbage bin, the kind with wheels on the bottom and a lid held in place by two handles. There are no holes in the body, so it should hold water. The axle for the wheels runs through its own tube and not through holes drilled into the body of the bin, so no worries about leaks there.

For this project, I nipped over to the hardware store and bought a 1/2" ball valve and a 1/2" female-threaded brass connector. Really, there should be a simple screw-together plastic bung apparatus on the shelves with flanges on either side (put one piece inside the hole, screw the other into place and presto! a watertight bung!). Sadly, there wasn't. If you find such a thing, let me know, as it'll probably be better than my device.

The project also requires some teflon tape (it's cheap, and worth having on hand for minor plumbing repairs) and a bit of silicone (I had some left over from sealing leaks around a window). Unlike normal plumbing, the water in the barrel will not be under pressure.

First, place the male end of the joint on the side of the barrel, near the bottom. Trace around it so you'll know how big a hole to make. Then drill small holes all the way around. When you're done, the bits between the holes should be easy to cut with an Olfa knife.

I knew this project was on-track when the resultant hole looked like it had been chewed by hearty city mice. Don't worry, it needn't be pretty. This is, after all, a grey-water barrel. And the hole will look better when it's done.

Check that the male end of the connector fits snugly into the hole.

Next, wrap the male threads on the faucet in teflon tape, then screw it into the connector. The teflon tape provides a watertight seal.

Run a generous bead of silicone around the hole. This will provide the seal between the barrel and the connector. Insert the connector so that the valve points down (that is, so it'll drain properly when you stand the barrel up to actually use it). Run your finger around the joint to smooth the silicone. Probably a good idea to put a bead on the inside of the barrel, too.

And shazam! You're done. Now let it dry, then take it outside and test it for leaks, as I will do with mine in the morning.

***Note: The "indoor/outdoor" silicone I used proved to be a mistake. It wasn't water-resistant and broke down. A better caulk might have worked, or the faucet kit from Lee Valley (There's a link to it in the comments section). I later fixed the problem using nuts and washers, and wrote about it here.***

Saturday, January 24, 2009

Water on the brain

Detail from a mural at Bridgepoint Health,
on the edge of the Don River, Canada's most polluted river.
Photo by Craig Saunders

I've been thinking about water lately. Every time I shower, or pull the plug on my son's bath, I think about all the water going down the drain. In a week, hundreds of gallons of fairly clean greywater flows from my house into the city's wastewater system. It doesn't need to.

My city has more than 9,000 kilometres of sewers connecting the homes of a few million people. The wastewater generally flows downhill to the lake, but sometimes must be pumped uphill at one of 45 pumping stations. The more we flush, the more electricity gets used to pump that waste. Then there's a 10.5-hour treatment process at the end.

That process takes a lot of energy. more than 190 million kilowatthours. Water systems are one of the biggest parts of any city's energy bill, and because of that, one of the biggest sources of greenhouse gas emissions. There's a lot a city can do, from replacing leaky old pipes to installing biogas systems to use some of the energy stored in all that poop-filled water. Homeowners can fix leaky faucets, take showers instead of baths, and really, do you need to take a full shower every day? Wouldn't a sponge bath in the sink (using just a few litres of water) suffice some days?

Every time I pull the plug on the bathtub, I think about all that water going down the drain. It's good water, with quite a few nutrients in it thanks to the soap. Then I think about my garden, a few hundred square feet of vegetables (well, it will be once the snow melts). Why not use the greywater on the garden?

I'm happy to take buckets out to the garden. I used to do this in London. But my garden paths are dirty, and I'd have to walk back and forth across the carpet in my bedroom countless times. The obvious solution is some sort of a water barrel on the back porch. Then I could carry buckets to fill it, then go outside and do the watering without tracking dirt throughout the house.

But where to get a suitable barrel? I was wondering about this, and today it came to me. The city just delivered new garbage bins. We have to use these official bins if we want our rubbish collected. That means the big, old plastic bin we had been using is just sitting at the side of the house. If the upstairs neighbours don't object, I'll put it on the back deck and use it for greywater. Now I just need to figure out some sort of spigot system for the bottom.

Then I'll have a great greywatering system for my garden. My veg will love it, it will reduce the amount of relatively clean water the city will have to treat, and it will reduce the amount of water they need to pump into the system, since I'll be using less municipal water for the garden. A win-win-win situation.

Now I just have to wait until the snow melts.